If I remember correctly it’s a strong magnet that you screw into the top of the cartridge and set the handle on the magnet. Don’t make the mistake I did, I put the magnet on the cartridge and didn’t put the screw in it. I set the handle on for a dry fit to see how it looked. Damn magnet stuck hard in the handle and it’s a pain in the Fixing a leaky faucet handle is a relatively straightforward task that you can tackle on your own. Follow these handy steps to stop that pesky leak. To fix a leaky rotary ball faucet (or rotating ball faucet) you usually just tighten the cap or cap-adjusting ring. Tightening the cap works because most leaks in rotary ball faucets occur around the handle or spout. If that doesn’t stop the leak, buy a repair kit and replace the faucet’s internal parts. To fix a leaking Glacier Bay bathroom faucet, all you need to do is locate the leak and replace the cartridge. Outlined below are the exact steps you need to take to fix your bathroom faucet by yourself. Step 1. Turn off the water by closing the water valves below the faucet. Step 2. Pry out the rubber cap on the handle with a knife if there is Remove the Pfister Faucet Handle. Once the water is shut off, you can remove the handle of your Pfister kitchen faucet. Use an Allen wrench to remove the set screw that holds the handle in place. Once the set screw is removed, you should be able to pull the handle off. Lift the handle up straight to remove it from the faucet stem. To take the counter out, I would need to also remove the mirror on the right side. I would also need to remove the items on the counter, remove the antique washboard, and move the dryer back out of its neatly tucked-in spot. So, I basically had to deal with an unkempt, disorganized room again until I finally fixed the faucet. FLn6. Step 2: Handle and Dome. To remove the handle, flip open the little red/blue plastic nib on the side of the handle (see video). You will access a hole to get your Allen key (hex tool) and be able to unscrew the long screw that holds the handle on. Then, remove the dome (see photos) which should just slide up and off. 2. Remove the Faucet Handles and Cover the Plate. After turning off the water supply, the next step in fixing a leaky faucet handle is to remove the handle and cover plate. Usually, you’ll find a button or cap that covers the screw to the handles. Use a flathead screwdriver to remove the cover and expose the screw underneath gently. Here are the steps you need to take: Remove the head. To get to the faucet washer, you will first have to remove the head. Use a pipe wrench or water pump pliers to rotate the head counterclockwise. Once you feel it’s loose enough, hold the body of the faucet and slowly remove the head. Remove the washer. Step 1Step 1Find Out Which Faucet Handle is Causing the Leak. The first step in fixing a leaky, 2-handle faucet is to figure out which handle is leaking. First, turn off your cold-water valve and check your faucet, if it has stopped dripping, it’s the cold water handle. If it still has water dripping, turn off your hot water valve. To fix a leaky rotary ball faucet (or rotating ball faucet) you usually just tighten the cap or cap-adjusting ring. Tightening the cap works because most leaks in rotary ball faucets occur around the handle or spout. If that doesn’t stop the leak, buy a repair kit and replace the faucet’s internal parts.

fixing a leaking faucet handle